Shrink chuck 4,5° SK 30 - 03 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! Delivery: All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra <

Measures internal grooves

With wrench

- with mode

For the transfer of a defined torque

- Scanning surface Ø24

For holding tool holders with polygonal shank ISO 26623-1

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

Standard (over 25mm range)

Clamping screw

in conjunction with „KEMMLER Precision collet chuck ER"

Sealing capacity up to 80 bar

thin thread and pitch diameter oversize